Placing the mouse cursor over the Handrail Connection Macro will reveal the tooltip describing the scope and steps of this macro. How To Use It: Click the…
Placing the mouse cursor over the Bolted Gusset Plate Connection Macro will reveal the tooltip describing the scope and steps of this macro. The below is the…
A Splice Connection Macro can be created between a beam & a beam or a beam and a column. Placing the mouse cursor over the Splice…
Before analysing the building you must ensure that Project Parameters, Load Combinations, Wind & Storey Loads and Materials have been correctly defined. These settings are…
ProtaStructure can now calculate seismic loads in accordance with Indonesia (SNI 1726 :2019 ) seismic code, which is an adaptation of ASCE07. Go to Building Analysis dialog…
ProtaStructure can calculate seismic loads in accordance with India (IS 1893-2016) seismic code, which covers the key parts of IS codes. Click on Settings Center > Code section will…
ProtaStructure can calculate seismic loads in accordance with Philippines (NSCP2015) seismic code, which is an adaptation of UBC97. Go to Building Analysis dialog > Pre-analysis…
ProtaStructure can now calculate seismic loads in accordance EuroCode 8. Country specific requirements of the following National Annex have been implemented : MS EN 1998-1…
Lateral loads can be applied at each floor level of the analysis model, or individual Column/Wall nodes (Joint loads that can be assigned to individual…
Pre-Analysis Tab Concrete and steel grades are assigned to each member type from the “ Pre-Analysis ” tab page in the “ Building Analysis ” Form. Unit Weight of Member…
The Prota wheel